INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart. Click here PROCEDURE 1. INSTALL GLASS BREAKAGE SENSOR ECU (a) Install the glass breakage sensor ECU with the nut. Torque: 7.6 N·m {77 kgf·cm, 67 in·lbf} (b) Install the junction block with the 2 nuts. (c) Connect each connector. 2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (a) for Column Shift Type: Click here (b) for Floor Shift Type: Click here 4. INSTALL INSTRUMENT SIDE PANEL LH (a) for Column Shift Type: Click here (b) for Floor Shift Type: Click here 5. INSTALL COWL SIDE TRIM BOARD LH (a) for Double Cab: Click here (b) for CrewMax: Click here 6. INSTALL FRONT DOOR SCUFF PLATE LH (a) for Double Cab: Click here (b) for CrewMax: Click here 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 8. CHECK SRS WARNING LIGHT Click here |
Toyota Tundra Service Manual > Audio And Visual System: Illumination Circuit
DESCRIPTION Power is supplied to the radio and display receiver assembly and steering pad switch assembly illumination when the light control switch is in the tail or head position. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: The vehicle is equipped with a Supplemental Restraint System (SRS) whic ...
