Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio)

2. INSTALL NO. 2 RADIO RECEIVER BRACKET

(a) w/o Satellite Radio:

Install the No. 2 radio receiver bracket with the 3 bolts.

Torque:

3.5 N·m {36 kgf·cm, 31 in·lbf}

(b) w/ Satellite Radio:

Install the No. 2 radio receiver bracket with the 5 bolts.

Torque:

3.5 N·m {36 kgf·cm, 31 in·lbf}

3. INSTALL NO. 1 RADIO RECEIVER BRACKET

(a) w/o Satellite Radio:

Install the No. 1 radio receiver bracket with the 3 bolts.

Torque:

3.5 N·m {36 kgf·cm, 31 in·lbf}

(b) w/ Satellite Radio:

Install the No. 1 radio receiver bracket with the 5 bolts.

Torque:

3.5 N·m {36 kgf·cm, 31 in·lbf}

4. INSTALL NO. 1 NAVIGATION WIRE (w/ Satellite Radio)

5. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY

(a) Connect each connector.

(b) Insert the radio and display receiver assembly with bracket and attach the 2 guides and 3 clips on its backside.

NOTICE:

When inserting the radio receiver, do not press its knobs.

(c) Install the radio and display receiver assembly with bracket with the 4 bolts.

Torque:

5.5 N·m {56 kgf·cm, 49 in·lbf}

6. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).