Toyota Tundra Service Manual: Front Passenger Side Power Window Switch

Toyota Tundra Service Manual / Vehicle Interior / Window / Glass / Front Passenger Side Power Window Switch

Components

COMPONENTS

ILLUSTRATION

*1

FRONT UPPER ARMREST BASE PANEL RH

*2

POWER WINDOW REGULATOR SWITCH ASSEMBLY

Inspection

INSPECTION

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (w/o Jam Protection Function)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

4 (U) - 3 (B)

UP

Below 1 Ω

1 (D) - 2 (SD)

4 (U) - 5 (SU)

OFF

1 (D) - 2 (SD)

4 (U) - 5 (SU)

DOWN

1 (D) - 3 (B)
  • If the result is not as specified, replace the power window regulator switch assembly. Text in Illustration

    *a

    Component without harness connected

    (Power Window Regulator Switch Assembly)

2. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (w/ Jam Protection Function)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 (GND) - 6 (UP)

AUTO UP

Below 1 Ω

1 (GND) - 8 (AUTO)

4 (LED) - 7 (DOWN)

1 (GND) - 6 (UP)

MANUAL UP

1 (GND) - 7 (DOWN)

MANUAL DOWN

4 (LED) - 6 (UP)

OFF

4 (LED) - 7 (DOWN)

1 (GND) - 7 (DOWN)

AUTO DOWN

1 (GND) - 8 (AUTO)

4 (LED) - 6 (UP)
  • If the result is not as specified, replace the power window regulator switch assembly. Text in Illustration

    *a

    Component without harness connected

    (Power Window Regulator Switch Assembly)

Installation

INSTALLATION

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Attach the 2 claws to install the power window regulator switch assembly.

2. INSTALL FRONT UPPER ARMREST BASE PANEL RH

(a) Connect the 2 connectors.

(b) Attach the 2 clips and 5 claws to install the front upper armrest base panel RH.

Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT UPPER ARMREST BASE PANEL RH

(a) Using a moulding remover A, detach the 2 clips and 5 claws, and remove the front upper armrest base panel RH.

(b) Disconnect the 2 connectors.

2. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Detach the 2 claws and remove the power window regulator switch assembly.
    Removal

    Power Window Control System(w/ Jam Protection Function)

    See More:

    Toyota Tundra Service Manual > Power Seat Switch(w/o Seat Position Memory System): Installation
    INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See pa ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0134