Toyota Tundra Service Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Data List.

(e) According to the display on the Techstream, read the Data List.

Main Body:

Tester Display

Measurement Item/Range

Normal Condition

Diagnostic Note

D Door Courtesy SW

Driver side door courtesy switch signal / ON or OFF

ON: Driver door open

OFF: Driver door closed

-

P Door Courtesy SW

Front passenger side door courtesy switch signal / ON or OFF

ON: Front passenger door open

OFF: Front passenger door closed

-

2. ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Active Test.

(e) According to the display on the Techstream, perform the Active Test.

Main Body:

Tester Display

Test Part

Control Range

Diagnostic Note

IG OFF P/W Control Permission Output

Power window control permission output

ON or OFF

-

    Power Window Control System(w/o Jam Protection Function)

    Driver Side Power Window Auto Down Function does not Operate

    See More:

    Toyota Tundra Service Manual > Automatic Transmission System: Shift Solenoid "B" Control Circuit Low (Shift Solenoid Valve S2) (P0976,P0977)
    DESCRIPTION Shifting from 1st to 6th is performed in combination with ON and OFF operation of the shift solenoid valves SL1, SL2, S1, S2, S3, S4 and SR, which are controlled by the ECM. If an open or short circuit occurs in any of the shift solenoid valves, the ECM controls the remaining normal shif ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0268