DESCRIPTION
WIRING DIAGRAM
PROCEDURE
(a) Remove the front power window regulator motor assembly LH (See page
(b) Inspect the front power window regulator motor assembly LH (See page
(a) Disconnect the N2 master switch connector. (b) Disconnect the N3 motor connector. (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
(a) Remove the power window regulator master switch assembly (See page
(b) Inspect the power window regulator master switch assembly (See page
|
Toyota Tundra Service Manual > Sfi System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. CUSTOMER PROBLEM ANALYSIS NEXT 3. CONNECT TECHSTREAM TO DLC3* HINT: If the display indicates a communication fault in the Techstream, inspect the DLC3. When any CAN communication system DTCs are out ...