Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

3. REMOVE CENTER LOWER INSTRUMENT COVER

4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

5. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY

6. REMOVE NO. 1 NAVIGATION WIRE

(a) Disconnect each connector and remove the No. 1 navigation wire.

7. REMOVE NO. 1 RADIO RECEIVER BRACKET

(a) Remove the 5 bolts and No. 1 radio receiver bracket.

8. REMOVE NO. 2 RADIO RECEIVER BRACKET

(a) Remove the 5 bolts and No. 2 radio receiver bracket.

9. REMOVE STEREO COMPONENT TUNER ASSEMBLY

(a) Detach the 2 guides and remove the stereo component tuner assembly as shown in the illustration.

    Installation

    Satellite Radio Tuner(for Floor Shift Type)

    See More:

    Toyota Tundra Service Manual > Tire Pressure Warning System: Lost Communication with Brake System Control Module (U0129/29)
    DESCRIPTION The tire pressure warning ECU and receiver receives signals from the skid control ECU (brake actuator assembly) assembly via the CAN communication system. DTC No. Detection Item DTC Detection Condition Trouble Area Note U0129/29 Lost Communication with Brake System Control Module Lost co ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.035