FREEZE FRAME DATA 1. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. (e) Select a PTC to display its Freeze Frame Data. 2. LIST OF FREEZE FRAME DATA (a) Refer to "Data List / Active Test" (See page
|
Toyota Tundra Service Manual > Engine Unit: Inspection
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SET BOLT (a) Using a vernier caliper, measure the length of the cylinder head bolt from the seat to the end. Standard length: 141.3 to 142.7 mm (5.56 to 5.62 in.) Maximum length: 143.7 mm (5.66 in.) If the length is more than the maximum, replace the cyl ...
).
