Toyota Tundra Service Manual: Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

Toyota Tundra Service Manual / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System / Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

PROCEDURE

1.

CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY

(a) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

J141-1 (MUTE) - Body ground

Ignition switch ACC, audio system playing

→ Changing modes

Above 3.5 V

→ Below 1 V

Text in Illustration

*a

Component with harness connected

(Stereo Component Amplifier Assembly)

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.

CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)

(a) Disconnect the J135 navigation receiver assembly connector.

(b) Disconnect the J141 stereo component amplifier assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

J135-16 (MUT1) - J141-1 (MUTE)

Always

Below 1 Ω

J135-16 (MUT1) - Body ground

Always

10 kΩ or higher

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

3.

CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)

(a) Disconnect the navigation receiver assembly connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

J135-16 (MUT1) - Body ground

Ignition switch ACC, audio system is playing

Above 3.5 V

Text in Illustration

*a

Front view of wire harness connector

(to Navigation Receiver Assembly)

Result

Result

Proceed to

OK (for Column Shift Type)

A

OK (for Floor Shift Type)

B

NG

C

A

REPLACE NAVIGATION RECEIVER ASSEMBLY

B

REPLACE NAVIGATION RECEIVER ASSEMBLY

C

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

    Microphone Circuit between Microphone and Navigation Receiver Assembly

    Navigation Receiver Assembly Power Source Circuit

    See More:

    Toyota Tundra Service Manual > Lighting System: Door Courtesy Switch Circuit
    DESCRIPTION The main body ECU (multiplex network body ECU) detects the condition of the door courtesy light switch assembly. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Using the Techstream, read the Data List. Click here Main Body Tester Display Measurement Item / Range Normal Condi ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0099