Toyota Tundra Service Manual: Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT

HINT:

  • Perform this check with the portable player volume set at an appropriate level.
  • Make sure there are no obstructions between the portable player and navigation receiver assembly that may block signals, and that the portable player and navigation receiver assembly are not excessively far apart.
  • Make sure devices other than the navigation receiver assembly are not connected to the portable player.
  • Make sure there is no interference from a wireless LAN, etc.

PROCEDURE

1.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the same problem does not occur in the sound heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.

OK:

The same problem does not occur in the sound heard from the speakers.

NG

MALFUNCTION IN PORTABLE PLAYER

OK

2.

REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES

(a) Remove additional devices which use radio waves.

(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.

OK:

The same problem does not occur in the sound heard from the speakers.

OK

END (ADDITIONAL DEVICES ARE DEFECTIVE)

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    No Sound can be Heard from Speakers

    Noise Occurs

    See More:

    Toyota Tundra Service Manual > Blind Spot Monitor System: Short to GND or Open in Buzzer (C1ABE)
    DESCRIPTION DTC C1ABE is stored when the blind spot monitor sensor LH detects a short to ground or open in the RCTA buzzer (blind spot monitor buzzer) circuit. DTC No. DTC Detection Condition Trouble Area C1ABE Both of the following conditions are met: The blind spot monitor system is on The blind s ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0198