Toyota Tundra Service Manual: Noise Occurs

PROCEDURE

1.

NOISE CONDITION

(a) Check from which direction the noise comes (front left or right, or rear left or right).

OK:

The location of the noise source can be determined.

NG

GO TO STEP 3

OK

2.

CHECK SPEAKERS

(a) Check the installation conditions of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other failures.

Result

Result

Proceed to

No malfunction is found

A

A speaker is installed incorrectly

B

Foreign objects are in the speaker

C

A speaker cone paper is broken

D

B

REINSTALL SPEAKER

C

REMOVE FOREIGN OBJECT

D

REPLACE SPEAKER

A

3.

CHECK NOISE CONDITIONS

(a) Check the noise condition.

HINT:

The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.

Condition under which Noise Occurs

Noise Source

Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped.

Generator

Noise occurs during air conditioning or heater operation.

Blower motor

Noise occurs when the horn switch is pressed and released or when pressed and held.

Horn

Noise occurs synchronously with the turn signal blinking pattern.

Flasher

Noise occurs during window washer operation.

Washer

Noise occurs during wiper operation.

Wiper

Noise occurs when the brake pedal is depressed.

Stop light switch

Others

Static electricity

HINT:

  • In the left column of the table, find the situation that matches the customer's complaint. Then, in the right column, find the part that is causing the noise. Check the respective noise filter.
  • To save time and avoid a misdiagnosis, first make sure that the noise is not coming from outside the vehicle.
  • Troubleshoot noises in descending order of loudness.
  • Setting the radio to a frequency where no signal is received may make recognition of the noise problem easier.

OK:

The noise source cannot be determined.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE NOISE SOURCE

    Noise Occurs or Sound Skips when Portable Player Plays

    Operation Check

    See More:

    Toyota Tundra Service Manual > Power Seat Switch(w/o Seat Position Memory System): Inspection
    INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH LH (a) Check the resistance of the front power seat switch LH. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Slide Switch Tester Connection Switch Condition Specified Condition 5 (SLDF) - 8 (B) 5 ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0389