DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.
CAUTION / NOTICE / HINT NOTICE: When checking for DTCs, make sure that the blind spot monitor system is turned on. PROCEDURE
(a) Clear the DTCs (See page
(b) Recheck for DTCs and check if the same DTC is output again (See page
OK: No DTCs are output.
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS CHECK FOR INTERMITTENT PROBLEMS HINT: A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the Data List function of the Techstream. (a) Turn the ignition switch off. (b) Connect the Techstrea ...
).
