DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction.
CAUTION / NOTICE / HINT NOTICE: When checking for DTCs, make sure that the blind spot monitor system is turned on. PROCEDURE
(a) Clear the DTCs (See page
(b) Recheck for DTCs and check if the same DTC is output again (See page
OK: No DTCs are output.
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Open in Front Speed Sensor RH (C1330-C1467)
DESCRIPTION Each speed sensor detects wheel speed and sends signals to the skid control ECU (brake actuator assembly). These signals are used by the ABS control. HINT: The output voltage values shown below are for when the vehicle wire harnesses are connected to the skid control ECU (brake actuator ...
).
