Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Audio, Visual, Telematics / Park Assist / Monitoring / Clearance Sonar Main Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

7 (IG) - 8 (SK)

Sonar switch off

10 kΩ or higher

Sonar switch on

Below 1 Ω

If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

(b) Check that the switch illuminates.

OK:

Tester Connection

Specified Condition

Battery positive (+) → Terminal 1 (ILL+)

Battery negative (-) → Terminal 6 (ILL-)

Illuminates

If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

Text in Illustration

*a

Component without harness connected

(Back Sonar or Clearance Sonar Switch Assembly)
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Trailer Brake Control Ecu: Components
    COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD RH *2 FRONT DOOR SCUFF PLATE RH *3 INSTRUMENT SIDE PANEL RH *4 LOWER INSTRUMENT PANEL *5 LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH *6 LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY *7 NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY *8 TRAILER B ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0112