REMOVAL CAUTION / NOTICE / HINT NOTICE:
HINT: After replacing the brake control with bracket relay, the gain value is set to 5.0 (initial value). PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing. Click here NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 3. REMOVE FRONT DOOR SCUFF PLATE RH Click here 4. REMOVE COWL SIDE TRIM BOARD RH Click here
5. INSTALL INSTRUMENT SIDE PANEL RH Click here 6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH Click here 7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 8. REMOVE LOWER INSTRUMENT PANEL Click here 9. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 10. REMOVE TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY)
(b) Remove the 2 bolts and trailer brake control ECU (brake control with bracket relay). |
Toyota Tundra Service Manual > Audio And Visual System: AV Signal Stoppage (Low Battery Voltage) (B158F)
DESCRIPTION This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily. DTC Code DTC Detection Condition Trouble Area B158F A video or audio signal is interrupted when the battery voltage drops. Radio an ...