Toyota Tundra Owners Manual: Windshield wipers and washer

Toyota Tundra Owners Manual / Driving / Operating the lights and wipers / Windshield wipers and washer

Operating the wiper lever

The wipers or washer operates by operating the lever as follows:

Vehicles without intermittent type

(U.S.A.) or (Canada) Off
(U.S.A.) or (Canada) Low speed windshield wiper operation
(U.S.A.) or (Canada) High speed windshield wiper operation
(U.S.A.) or (Canada) Temporary operation

Operating the lights and wipers

Washer operation

Pulling the lever towards you operate the washer.

Operating the lights and wipers

Vehicles with intermittent type

(U.S.A.) or (Canada) Off
(U.S.A.) or (Canada) Intermittent windshield wiper operation
(U.S.A.) or (Canada) Low speed windshield wiper operation
(U.S.A.) or (Canada) High speed windshield wiper operation
(U.S.A.) or (Canada) Temporary operation

Operating the lights and wipers

Wiper intervals can be adjusted when intermittent operation is selected.

Increases the intermittent windshield wiper frequency
Decreases the intermittent windshield wiper frequency

Operating the lights and wipers

Washer/wiper dual operation

Pulling the lever towards you operates the wipers and washer.

Wipers will automatically operate a couple of times after the washer squirts.

Operating the lights and wipers

■The windshield wipers and washer can be operated when The engine switch is in the "ON" position.

■If no windshield washer fluid sprays Check that the washer nozzles are not blocked if there is washer fluid in the windshield washer fluid reservoir.

WARNING

■Caution regarding the use of washer fluid When it is cold, do not use the washer fluid until the windshield becomes warm. The fluid may freeze on the windshield and cause low visibility. This may lead to an accident, resulting in death or serious injury.

NOTICE

■When the windshield is dry Do not use the wipers, as they may damage the windshield.

■When the washer fluid tank is empty Do not operate the switch continually as the washer fluid pump may overheat.

■When a nozzle becomes blocked In this case, contact your Toyota dealer.

Do not try to clear it with a pin or other object. The nozzle will be damaged.

Automatic High Beam

Refueling

See More:

Toyota Tundra Service Manual > Wireless Door Lock Control System: Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT BATTERY VOLTAGE (a) Measure the vehicle battery voltage. Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the battery. SELF-DIAGNOSTIC MODE (a) Connect the Techstream to the DLC3. (b) Turn the ignition s ...