Toyota Tundra Service Manual: Problem Symptoms Table

Toyota Tundra Service Manual / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page.

NOTICE:

When replacing the skid control ECU (brake actuator assembly), sensors, etc., turn the ignition switch off.

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Vehicle Stability Control System

Symptom

Suspected Area

Link

ABS warning light abnormal (Remains on)

Refer to the procedure for "ABS Warning Light Remains ON"

ABS warning light abnormal (Does not come on)

Refer to the procedure for "ABS Warning Light does not Come ON"

Brake warning light abnormal (Remains on)

Refer to the procedure for "Brake Warning Light Remains ON"

Brake warning light abnormal (Does not come on)

Refer to the procedure for "Brake Warning Light does not Come ON"

Slip indicator light abnormal (Remains on)

Refer to the procedure for "Slip Indicator Light Remains ON"

Slip indicator light abnormal (Does not come on)

Refer to the procedure for "Slip Indicator Light does not Come ON"

Excessive brake pedal travel (No fluid leaks and no air in system)

Refer to the procedure for "Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)"

ABS does not operate

Refer to the procedure for "ABS does not Operate"

ABS operates before necessary when braking

Refer to the procedure for "ABS Operates Before Necessary When Braking"

VSC does not operate or VSC does not operate correctly

Refer to the procedure for "VSC does not Operate or VSC does not Operate Correctly"

Brake actuator operation sound is loud during initial check

Refer to the procedure for "Brake Actuator Operation Sound is Loud during Initial Check"

VSC OFF switch (traction control switch) abnormal

Refer to the procedure for "VSC OFF Switch Circuit"

    Precaution

    Slip Indicator Light does not Come ON

    See More:

    Toyota Tundra Service Manual > Maintenance: Outside Vehicle
    General MaintenanceGENERAL MAINTENANCE CAUTION / NOTICE / HINT Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0093