DISASSEMBLY PROCEDURE 1. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY  (a) Using a T25 "TORX" socket wrench, remove the screw and reservoir. 2. REMOVE MASTER CYLINDER RESERVOIR GROMMET (a) Remove the 2 grommets. |
Toyota Tundra Service Manual > Side Moulding: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedures listed below are for the LH side. PROCEDURE 1. INSTALL REAR BODY NO. 3 PROTECTOR LH HINT: When installing the rear body No. 3 protector LH, heat the vehicle body and rear body No. 3 protector LH ...
