Toyota Tundra Service Manual: Installation

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Cooling / Water Pump / Installation

INSTALLATION

PROCEDURE

1. INSTALL WATER PUMP ASSEMBLY

(a) Install a new gasket and the water pump assembly with the 8 bolts shown in the illustration.

Torque:

for bolt A :

47 N·m {479 kgf·cm, 35 ft·lbf}

for bolt B :

23 N·m {235 kgf·cm, 17 ft·lbf}

for bolt C :

20 N·m {204 kgf·cm, 15 ft·lbf}

2. INSTALL WATER PUMP PULLEY

(a) Temporarily install the water pump pulley with the 4 bolts.

(b) Using SST, hold the water pump pulley and tighten the 4 bolts.

SST: 09960-10010

09962-01000

09963-01000

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

3. INSTALL WATER INLET HOUSING

(a) Install a new gasket to the water pump assembly.

(b) Install the water inlet housing with the 3 bolts.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

4. CONNECT NO. 5 WATER BY-PASS HOSE

(a) Connect the No. 5 water by-pass hose.

HINT:

The direction of hose clamp is indicated in the illustration.

5. CONNECT NO. 8 WATER BY-PASS HOSE

(a) Connect the No. 8 water by-pass hose.

HINT:

The direction of hose clamp is indicated in the illustration.

6. INSTALL NO. 1 WATER BY-PASS HOSE

(a) Install the No. 1 water by-pass hose.

HINT:

The direction of hose clamp is indicated in the illustration.

7. INSTALL WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

(See page )

8. INSTALL FAN SHROUD

(See page )

See More:

Toyota Tundra Service Manual > Rear Bumper (for Steel Type Bumper): Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR BUMPER PLATE LH (a) Detach the 3 claws and clip and remove the rear bumper plate LH. 2. REMOVE REAR BUMPER PLATE RH HINT: Use the same procedure described for the LH side. 3. REMOVE REAR BUMPER PAD SUB-ASSEMBLY LH (a) Remove the 3 clips. (b) Detach the 12 claws a ...

Toyota Tundra Service Manual: Installation

Components

On-vehicle Inspection

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual