Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Emission Control / Air Switching Valve(for Bank 1) / Removal

REMOVAL

PROCEDURE

1. DISCONNECT NO. 2 AIR HOSE

(a) Disconnect the air switching valve assembly connector.

(b) Slide the clamp and disconnect the No. 2 air hose.

2. REMOVE AIR SWITCHING VALVE ASSEMBLY

(a) Remove the bolt and disconnect the wire harness clamp bracket from the cylinder head cover.

(b) Remove the 2 bolts.

(c) Remove the 3 bolts, air switching valve assembly and gasket.

NOTICE:

Be careful not to damage the installation surface of the gaskets.
    Installation

    Air Switching Valve(for Bank 2)

    See More:

    Toyota Tundra Service Manual > Front Axle Hub: On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE FRONT WHEEL 2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH 3. REMOVE FRONT DISC 4. REMOVE FRONT AXLE HUB GREASE CAP LH (for 4WD) 5. INSPECT FRONT AXLE HUB BEARING LOOSENESS (a) Using a dial indicator, measure the looseness near the center of the axle hub ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.039