Toyota Tundra Service Manual: Installation

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Emission Control / Air Switching Valve(for Bank 1) / Installation

INSTALLATION

PROCEDURE

1. INSTALL AIR SWITCHING VALVE ASSEMBLY

(a) Install a new gasket and the air switching valve assembly with the 3 bolts.

Torque:

24 N·m {245 kgf·cm, 18 ft·lbf}

Text in Illustration

*1	Air Switching Valve Assembly
*2	No. 4 Air Tube
*a	Claw

NOTICE:

Make sure the gasket's claws are not caught between the air switching valve assembly and No. 4 air tube.

(b) Install the 2 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

Torque:

8.0 N·m {82 kgf·cm, 71 in·lbf}

2. CONNECT NO. 2 AIR HOSE

(a) Align the paint mark with the projection and connect the No. 2 air hose, and slide the clamp to secure the hose.

Text in Illustration

*a	Paint Mark
*b	Projection

HINT:

Make sure the direction of the hose clamp is as shown in the illustration.

(b) Connect the air switching valve assembly connector.

See More:

Toyota Tundra Service Manual > Front Airbag Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH and RH sides. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore ...

Toyota Tundra Service Manual: Installation

Inspection

Removal

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual