Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Emission Control / Canister / Inspection

INSPECTION

PROCEDURE

1. INSPECT CHARCOAL CANISTER ASSEMBLY

(a) Visually check the charcoal canister assembly for cracks or damage.

If cracks or damage are found, replace the charcoal canister assembly.

(b) Check charcoal canister assembly operation.

(1) With the purge port closed, blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into the vent line port, and check that air flows from the air inlet line port.

Text in Illustration

*a	Vent Line Port
*b	Air Inlet Line Port
*c	Purge Line Port
*d	Air

If the result is not as specified, replace the charcoal canister assembly.

(2) With the vent port closed, blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into the air inlet line port, and check that air flows from the purge line port.

Text in Illustration

*a	Vent Line Port
*b	Air Inlet Line Port
*c	Purge Line Port
*d	Air

If the result is not as specified, replace the charcoal canister assembly.

(1) Connect a pressure gauge to the vent line port of the charcoal canister assembly.

Text in Illustration

*1	Pressure Gauge
*a	Vent Line Port
*b	Air Inlet Line Port
*c	Purge Line Port

(2) With the purge line port and air inlet line port closed, apply 20 kPa (150 mmHg, 5.91 in.Hg) of pressurized air into the vent line port, and then confirm that pressure is retained for 1 minute.

If the result is not as specified, replace the charcoal canister assembly.

(d) Check the canister pump module.

(1) Connect a positive (+) lead from the battery to terminal 5 and a negative (-) lead to terminal 1.

(2) Check that a clicking sound is heard from the canister pump module.

If the result is not as specified, replace the canister pump module.

See More:

Toyota Tundra Service Manual > Front Lower Suspension Arm: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (see page ). PROCEDURE 1. TEMPORARILY INSTALL FRONT NO. 1 SUSPENSION ARM LOWER SU ...

Toyota Tundra Service Manual: Inspection

Components

Installation

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual