INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR  (a) Partially immerse the sensor in water and warm up the water. (b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the engine coolant temperature sensor. NOTICE: When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry. HINT: If the result is as specified, do not replace the engine coolant temperature sensor. |
Toyota Tundra Service Manual > Radiator Grille: Removal
REMOVAL PROCEDURE 1. REMOVE RADIATOR SIDE GRILLE LH (a) Detach the 2 claws and 3 guides as shown in the illustration to remove the radiator side grille LH. 2. REMOVE RADIATOR GRILLE SUB-ASSEMBLY (a) w/ Toyota Safety Sense P: (1) Disconnect the millimeter wave radar sensor connector. (b) Put protecti ...
