Toyota Tundra Service Manual: Lost Communication with ECM / PCM "A" (U0100,U0101,U0123,U0126,U0129,U0142,U0155)

U0100

Lost Communication with ECM / PCM "A"

After the ignition switch is turned to ON for 3 seconds or more, when the vehicle is being driven at a speed of 1 km/h or 1 mph or more, a communication error between the ECM and forward recognition camera is detected for approximately 5 seconds or more.

• CAN communication system
• ECM
• Forward recognition camera

U0101

Lost Communication with TCM

After the ignition switch is turned to ON for 3 seconds or more, when the vehicle is being driven at a speed of 1 km/h or 1 mph or more, a communication error between the TCM (ECM) and forward recognition camera is detected for approximately 5 seconds or more.

• CAN communication system
• TCM (ECM)
• Forward recognition camera

U0123

Lost Communication with Yaw Rate Sensor Module

After the ignition switch is turned to ON for 3 seconds or more, when the vehicle is being driven at a speed of 1 km/h or 1 mph or more, a communication error between the yaw rate and acceleration sensor (airbag sensor assembly) and forward recognition camera is detected for approximately 5 seconds or more.

• CAN communication system
• Yaw rate and acceleration sensor (airbag sensor assembly)
• Forward recognition camera

U0126

Lost Communication with Steering Angle Sensor Module

3 seconds after the ignition switch is turned to ON, a communication error between the spiral cable with sensor sub-assembly and the forward recognition camera is detected for approximately 5 seconds or more.

• CAN communication system
• Spiral cable with sensor sub-assembly
• Forward recognition camera

U0129

Lost Communication with Brake System Control Module

3 seconds after the ignition switch is turned to ON, a communication error between the skid control ECU (brake actuator assembly) and the forward recognition camera is detected for approximately 5 seconds or more.

• CAN communication system
• Skid control ECU (brake actuator assembly)
• Forward recognition camera

U0142

Lost Communication with Body Control Module "B"

3 seconds after the ignition switch is turned to ON, a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for approximately 5 seconds or more.

• CAN communication system
• Main body ECU (multiplex network body ECU)
• Forward recognition camera

U0155

Lost Communication with Combination Meter

3 seconds after the ignition switch is turned to ON, a communication error between the combination meter assembly and the forward recognition camera is detected for approximately 50 seconds or more.

• CAN communication system
• Combination meter assembly
• Forward recognition camera

1.

CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)

DTC U0100, U0101, U0123, U0126, U0129, U0142 or U0155 are not output

A

DTC U0100, U0101, U0123, U0126, U0129, U0142 or U0155 is output

B

USE SIMULATION METHOD TO CHECK

GO TO CAN COMMUNICATION SYSTEM