Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE RADIATOR GRILLE

Click here

2. REMOVE MILLIMETER WAVE RADAR WIRE

(a) for Type A:

(1) Disconnect the connector.

(2) Using a clip remover, detach the 3 clamps and remove the millimeter wave radar wire.

(b) for Type B:

(1) Disconnect the connector.

(2) Using a clip remover, detach the 3 clamps and remove the millimeter wave radar wire.

(1) Disconnect the connector.

(2) Using a clip remover, detach the 3 clamps and remove the millimeter wave radar wire.

3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.

(a) for Type A:

	Bolt
	Screw

(1) Remove the 2 bolts and screw.

(2) Detach the guide and remove the millimeter wave radar sensor assembly.

(b) for Type B:

	Bolt
	Screw

(1) Remove the 2 bolts and screw.

(2) Detach the guide and remove the millimeter wave radar sensor assembly.

	Bolt
	Screw

(1) Remove the 2 bolts and screw.

(2) Detach the guide and remove the millimeter wave radar sensor assembly.

Toyota Tundra Service Manual > Occupant Classification System: Rear Occupant Classification Sensor LH Collision Detection (B1787)
DESCRIPTION DTC B1787 is set when the occupant classification ECU receives a collision detection signal, which is sent by the rear occupant detection sensor LH when an accident occurs. DTC B1787 is also set when the front seat frame with adjuster RH is subjected to a strong impact, even if an actual ...

Toyota Tundra Owners Manual