INSPECTION PROCEDURE 1. INSPECT FRONT NO. 1 SUSPENSION ARM LOWER SUB-ASSEMBLY LH (a) As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut. (b) Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn. Standard turning torque: 3.0 to 10.0 N*m (31 to 102 kgf*cm, 27 to 89 in.*lbf) (c) Check for any cracks and grease leaks on the ball joint dust cover. |
Toyota Tundra Service Manual > Automatic Transmission System: Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) (P2716)
DESCRIPTION Refer to DTC P0894 (See page ). DTC Code DTC Detection Condition Trouble Area P2716 Open or short is detected in the shift solenoid valve SLT circuit for 1 second or more while driving (1-trip detection logic). Open or short in shift solenoid valve SLT circuit Shift solenoid valve SLT EC ...