Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Steering / Steering Column / Steering Column Assembly(for Manual Tilt And Manual Telescopic Steering Column) / Inspection

INSPECTION

PROCEDURE

1. INSPECT STEERING COLUMN ASSEMBLY

(a) Measure the length of the steering main shaft.

Standard length(A):

529.5 mm (1.74 ft.)

(b) Inspect the bushings.

(1) Check that the 2 bushings are securely installed to the steering column assembly.

Text in Illustration

Bushing

If the bushings are missing or damaged, replace the steering column assembly with a new one.

(2) Check the 2 bushings for deformation and damage.

If the bushings are deformed or damaged, replace the steering column assembly with a new one.

(1) Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

Standard Dimension:

A	B
3 mm (0.118 in.)	10 mm (0.394 in.)

Text in Illustration

Capsule

If the capsules are not positioned as specified, replace the steering column assembly with a new one.

(2) Check the 2 capsules for deformation and damage.

If either of the capsules is deformed, loose, missing or damaged, replace the steering column assembly with a new one.

See More:

Toyota Tundra Service Manual > Front Propeller Shaft Assembly: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING (a) Apply MP grease to a new spider and bearings. NOTICE: Be careful not to apply too much grease. (b) Fit the spider to the yoke. (c) Measure dimension A between the snap ring grooves. (d) Insert the spider bearing ...

Toyota Tundra Service Manual: Inspection

Disassembly

Installation

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual