Toyota Tundra Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air conditioner / Trouble Codes.

(e) Check for DTCs.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air conditioner / Trouble Codes.

(e) Clear the DTCs.

3. INDICATOR CHECK

(a) Press and hold the A/C control AUTO switch and Recirculation / Fresh switch simultaneously, and turn the ignition switch ON. Continue holding the 2 switches until the panel diagnosis mode begins.

(b) Check that all indicators turn on and off 4 times in succession at 1 second intervals.

HINT:

  • After the indicator check is completed, the system enters the DTC mode automatically.
  • Press the "OFF" switch to cancel the indicator check.
    Diagnostic Trouble Code Chart

    ECU Power Source Circuit

    See More:

    Toyota Tundra Service Manual > Front Power Seat Control System(w/ Memory): Short in Sensor with Motor Power Supply Circuit (B2658)
    DESCRIPTION This DTC is stored when a power seat motor operates (a position control sensor is being supplied with power) and the power supply voltage does not rise to the specified value. DTC Code DTC Detection Condition Trouble Area B2658 A problem with the voltage supplied to the position control ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2023 Copyright www.ttundra.com
    0.0184