Toyota Tundra Service Manual: Air Inlet Damper Control Servo Motor Circuit (B1442/42)

DESCRIPTION

The air inlet damper servo motor sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air inlet damper to any position, which controls the intake air settings (FRESH, FRESH / RECIRCULATION and RECIRCULATION).

HINT:

Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.

DTC Code

DTC Detection Condition

Trouble Area

B1442/42

Air inlet damper position sensor value does not change even if air conditioning amplifier operated air inlet damper servo motor

  • Air inlet servo motor
  • Air conditioning harness
  • Air conditioning amplifier

WIRING DIAGRAM

PROCEDURE

1.

READ VALUE USING TECHSTREAM (AIR INLET DAMPER TARGET PULSE)

(a) Use the Data List to check if the air inlet servo motor is functioning properly.

Air Conditioner

Tester Display

Measurement Item / Range

Normal Condition

Diagnostic Note

Air Inlet Damper Targ Pulse

Air inlet damper target pulse /

Min.: 0, Max.: 255

REC: 7

FRS: 28

-

OK:

The display is as specified in the normal condition.

Result

Result

Proceed to

OK (Checking from the DTC)

A

OK (Checking from the PROBLEM SYMPTOMS TABLE)

B

NG

C

B

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER

A

2.

REPLACE AIR INLET SERVO MOTOR

(a) Temporarily replace the air inlet servo motor with a new one (see page ).

HINT:

Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new one and check that the condition returns to normal.

NEXT

3.

CHECK FOR DTC

(a) Clear the DTC (see page ).

(b) Check for DTC (see page ).

OK:

DTC is not output.

OK

END (AIR INLET SERVO MOTOR IS DEFECTIVE)

NG

4.

REPLACE AIR CONDITIONING HARNESS

(a) Replace the air conditioning harness.

NEXT

5.

CHECK FOR DTC

(a) Clear the DTC (see page ).

(b) Check for DTC again (see page ).

OK:

DTC is not output.

OK

END (AIR CONDITIONING HARNESS IS DEFECTIVE)

NG

REPLACE AIR CONDITIONING AMPLIFIER

    Air Mix Damper Control Servo Motor Circuit (Passenger Side) (B1441/41)

    Air Outlet Damper Control Servo Motor Circuit (B1443/43)

    See More:

    Toyota Tundra Service Manual > Transmission Control Cable(for Column Shift Type): Installation
    INSTALLATION PROCEDURE 1. INSTALL COLUMN SHIFT TRANSMISSION CONTROL CABLE ASSEMBLY (a) Insert the transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} (b) Connect the cable to the steering column shaft bracke ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0365