CAUTION / NOTICE / HINT HINT:
PROCEDURE
Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the battery before proceeding.
(a) Use the Techstream to check if the CAN communication system is functioning normally. Click here
(a) Check for DTCs and note any codes that are output. Click here (b) Delete the DTC. Click here (c) Recheck for DTCs. Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the operation indicated by the DTC.
(a) Refer to the problem symptoms table. Click here
(a) DATA LIST / ACTIVE TEST Click here (b) Terminals of ECU Click here (c) On-vehicle Inspection (d) Inspection
|
Toyota Tundra Service Manual > Fuel Pump: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FUEL SENDER GAUGE ASSEMBLY 2. REMOVE SUB TANK (a) Disconnect the fuel pump connector. (b) Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the 2 clamps. (c) Disconnect the fuel tube. (d) Using a screwdriver ...