Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (DOOR CONTROL SWITCH ASSEMBLY) (for Regular Cab)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Switch Condition

Specified Condition

1 (L) - 7 (E)

Lock

Below 1 Ω

1 (L) - 7 (E)

OFF

10 kΩ or higher

9 (UL) - 7 (E)

9 (UL) - 7 (E)

Unlock

Below 1 Ω

If the result is not as specified, replace the power window regulator master switch assembly (door control switch assembly).

Text in Illustration

*a

Component without harness connected

(Power Window Regulator Master Switch Assembly (Door Control Switch Assembly))

*b

Unlock

*c

Lock

2. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (DOOR CONTROL SWITCH ASSEMBLY) (for Double Cab, for Crew Max)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Switch Condition

Specified Condition

2 (L) - 1 (E)

Lock

Below 1 Ω

2 (L) - 1 (E)

OFF

10 kΩ or higher

9 (UL) - 1 (E)

9 (UL) - 1 (E)

Unlock

Below 1 Ω

If the result is not as specified, replace the power window regulator master switch assembly (door control switch assembly).

Text in Illustration

*a

Component without harness connected

(Power Window Regulator Master Switch Assembly (Door Control Switch Assembly))

*b

Unlock

*c

Lock

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Sfi System: Cold Start Ignition Timing Performance (P050B)
    DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC will be set after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the ignition timing at cold start. When the engine is start ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0099