Toyota Tundra Service Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Enter the following menus: Body Electrical / Main Body / Data List.

(d) Read the Data List according to the display on the Techstream.

Main Body

Tester Display

Measurement Item/Range

Normal Condition

Diagnostic Note

ACC SW

Ignition switch/ON or OFF

ON: Ignition switch ACC

OFF: Ignition switch off

"ON" is also displayed for this item when the ignition switch is ON.

IG SW

Ignition switch/ON or OFF

ON: Ignition switch ON

OFF: Ignition switch off

"OFF" is also displayed for this item when the ignition switch is ACC.

FL Door Courtesy SW

Front courtesy light switch LH/ON or OFF

ON: Driver side door is open

OFF: Driver side door is closed

-

FR Door Courtesy SW

Front courtesy light switch RH/ON or OFF

ON: Passenger side door is open

OFF: Passenger side door is closed

-

RR Door Courtesy SW

Rear courtesy light switch RH/ON or OFF

ON: Rear door RH is open

OFF: Rear door RH is closed

-

RL Door Courtesy SW

Rear courtesy light switch LH/ON or OFF

ON: Rear door LH is open

OFF: Driver side door is locked

-

FL Door Lock Pos

Driver side door unlock detection switch signal/ON or OFF

ON: Driver side door is unlocked

OFF: Driver side door is locked

-

FR Door Lock Pos

Front passenger side door unlock detection switch signal/ON or OFF

ON: Front passenger side door is unlocked

OFF: Front passenger side door is locked

-

RR-Door Lock Pos SW

Rear door lock position switch signal/ON or OFF

ON: Either of rear door LH or rear door RH is unlocked

OFF: Both of rear door LH and rear door RH are locked

-

RL-Door Lock Pos SW

Rear door lock position switch signal/ON or OFF

ON: Either of rear door LH or rear door RH is unlocked

OFF: Both of rear door LH and rear door RH are locked

-

Key Unlock Warning SW

Unlock warning switch/ON or OFF

ON: Ignition key is inserted

OFF: Ignition key is not inserted

-

2. ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows the relay, VSV, actuator and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Enter the following menus: Body Electrical / Main Body / Active Test.

(d) Perform the Active Test according to the display on the Techstream.

Main Body

Tester Display

Test Part

Control Range

Diagnostic Note

Wireless Buzzer

Wireless door lock buzzer

ON/OFF

-

    Customize Parameters

    Diagnosis System

    See More:

    Toyota Tundra Service Manual > Outer Mirror Switch: Installation
    INSTALLATION PROCEDURE 1. INSTALL OUTER MIRROR SWITCH ASSEMBLY (a) Attach the 2 claws to install the outer mirror switch assembly. 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 3. INSTALL INSTRUMENT SIDE PANEL LH 4. INSTALL COWL SIDE TRIM BOARD LH 5. INSTALL FRONT DOOR SCUFF PLATE L ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0345