Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH

(a) Check that the clearance measurements of areas A to J are within the standard range.

Standard measurement:

Area	Specified Condition	Area	Specified Condition
A	4.7 to 7.7 mm (0.185 to 0.303 in.)	F	0.7 to 3.7 mm (0.0276 to 0.146 in.)
B	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)	G	3.7 to 6.7 mm (0.146 to 0.264 in.)
C	3.7 to 6.7 mm (0.146 to 0.264 in.)	H	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
D	0.8 to 3.8 mm (0.0315 to 0.150 in.)	I	3.7 to 6.7 mm (0.146 to 0.264 in.)
E	3.7 to 6.7 mm (0.146 to 0.264 in.)	J	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)

Toyota Tundra Service Manual > How To Troubleshoot Ecu Controlled Systems: Electronic Circuit Inspection Procedure
ELECTRONIC CIRCUIT INSPECTION PROCEDURE 1. BASIC INSPECTION (a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS (1) Unless otherwise stated, all resistance measurements should be made at an ambient temperature of 20°C (68°F). Resistance measurements may be inaccurate if measured at high temperatures ...

Toyota Tundra Owners Manual