Toyota Tundra Service Manual: Theft Deterrent System Presence Detection (B279C)

DESCRIPTION

This code is stored when an ECM that is incompatible with the engine immobiliser system is installed to the vehicle.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	Note
B279C	Theft Deterrent System Presence Detection	An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*).	ECM	Check for DTCs.

Vehicle Condition and Fail-safe Operation when Malfunction Detected

Vehicle Condition when Malfunction Detected	Fail-safe Operation when Malfunction Detected
Engine cannot be started	-

Related Data List and Active Test

DTC No.	Data List and Active Test
B279C	-

CAUTION / NOTICE / HINT

NOTICE:

If the ECM is replaced, refer to Registration.
Click here
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

PROCEDURE

CLEAR DTC

(a) Clear the DTCs.

Click here

2.	CHECK FOR DTC

(a) Start the engine.

(b) Check for DTCs.

Click here

HINT:

Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

OK:

DTC B279C is not output.

USE SIMULATION METHOD TO CHECK

3.	REPLACE ECM

(a) Replace the current ECM with the proper ECM.

END

Toyota Tundra Service Manual > Vehicle Stability Control System: Acceleration Sensor Internal Circuit (C1419,C1435)
DESCRIPTION These DTCs are stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly). DTC No. Detection Item DTC Detection Condition Trouble Area C1419 Acceleration Sensor Internal Circuit Wit ...

Toyota Tundra Owners Manual