INSTALLATION PROCEDURE 1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY (a) Install the headlight dimmer switch assembly to the steering column, making sure that the stopper protrusions and cutout parts align.  Text in Illustration
(b) While loosening the band clamp, attach the claw to install the headlight dimmer switch assembly. (c) Connect the connector.  Text in Illustration
2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (See page 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page 5. CHECK SRS WARNING LIGHT (See page |
Toyota Tundra Service Manual > Sfi System: Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0057,P0058,P0141,P0161,P102D,P105D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the Heated Oxygen (HO2) sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is turned off. The ECM provides a pulse width modulated co ...
