Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Vehicle Interior / Lighting / Headlight Leveling Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT HEADLIGHT LEVELING SWITCH

(a) Check the voltage.

(1) Connect the battery positive (+) lead to terminal 1 (B) and the negative (-) lead to terminal 5 (E).

(2) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

1 (B) - 2 (T)

0

10.4 to 11.2 V

1

8.52 to 9.24 V

2

6.6 to 7.32 V

3

4.68 to 5.40 V

4

2.76 to 3.48 V

5

0.84 to 1.56 V

If the result is not as specified, replace the headlight leveling switch.

Text in Illustration

*a

Component without harness connected

(Headlight Leveling Switch)

(b) Check the illumination.

(1) Apply battery voltage to the connector and check the illumination condition.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 3 (ILL+)

Battery negative (-) → Terminal 4 (ILL-)

Illuminates

If the result is not as specified, replace the headlight leveling switch.

Text in Illustration

*a

Component without harness connected

(Headlight Leveling Switch)
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART Engine Immobiliser System DTC No. Detection Item Link B2780 Push Switch / Key Unlock Warning Switch Malfunction B2784 Antenna Coil Open / Short B2793 Transponder Chip Malfunction B2794 Unmatched Encryption Code B2795 Unmatched Key Code B2796 No Communication in Immobili ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0121