INSTALLATION PROCEDURE 1. INSTALL HEADLIGHT LEVELING SWITCH (a) Attach the 2 claws to install the headlight leveling switch. 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
3. INSTALL INSTRUMENT SIDE PANEL LH
4. INSTALL COWL SIDE TRIM BOARD LH
5. INSTALL FRONT DOOR SCUFF PLATE LH for Double Cab: (See page for CrewMax: (See page |
Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Terminals Of Ecu
TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY (a) Disconnect the J26 transponder key ECU assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Tester Connection ...
