Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL AUTO HIGH BEAM SWITCH

(a) Attach the 2 claws to install the auto high beam switch to the lower instrument panel finish panel sub-assembly LH.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

3. INSTALL INSTRUMENT SIDE PANEL LH

4. INSTALL COWL SIDE TRIM BOARD LH

5. INSTALL FRONT DOOR SCUFF PLATE LH

for Double Cab:

(See page )

for CrewMax:

(See page )

    Inspection

    Removal

    See More:

    Toyota Tundra Service Manual > Blind Spot Monitor System: Short to GND in Outer Mirror Indicator(Master) (C1AB2)
    DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to ground in the outer rear view mirror indicator RH. DTC No. DTC Detection Condition Trouble Area C1AB2 Both of the following conditions are met: The blind spot monitor system is on The current that is sent from th ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0124