Toyota Tundra Service Manual: Diagnostic Trouble Code Chart

Toyota Tundra Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

HINT:

If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.

Meter/gauge system:

DTC Code	Detection Item	See page
B1500	Fuel Sender Open Detected
B1507	Open in Turn Signal Circuit
B1508	Short in Turn Signal / Hazard Flasher Circuit
B150A	Lost Communication with HMI-LAN
U0100	Lost Communication with ECM / PCM "A"
U0129	Lost Communication with Brake System Control Module
U0142	Communication with BODY ECU (Receive)
U0151	A/B ECU CAN communications fault
U0163	Last Communication With Navigation ECU
U0235	Lost Communication with Cruise Control Front Distance Range Sensor
U023A	Lost Communication with Front Camera Module

See More:

Toyota Tundra Service Manual > Side Airbag Sensor(for Double Cab): Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT SIDE AIRBAG SENSOR (a) Check that the ignition switch is OFF. (b) Check that the cable is disconnected from the battery negative (-) terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent air ...

Toyota Tundra Service Manual: Diagnostic Trouble Code Chart

Data List / Active Test

Dtc Check / Clear

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual