DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream ON. (d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes. (e) Check for DTCs. 2. CLEAR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream ON. (d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes (e) Clear the DTCs. |
Toyota Tundra Service Manual > Front Axle Hub: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. PROCEDURE 1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (for 2WD) (a) Apply MP grease to a new O-ring. (b) Install the O-ring to the axle hub. NOTICE: Do not d ...