Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Vehicle Interior / Pre-collision / Pre-collision System Warning Buzzer / Inspection

INSPECTION

PROCEDURE

1. INSPECT SKID CONTROL BUZZER ASSEMBLY

(a) Make sure that there is no looseness in the locking part and connecting part of the connector.

(b) Disconnect the skid control buzzer connector.

(c) Check the connector and terminals for deformation and corrosion.

OK:

No deformation or corrosion.

(d) Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the skid control buzzer, and check that the buzzer sounds.

OK:

The skid control buzzer assembly sounds.

If the result is not as specified, replace the skid control buzzer assembly.

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Front Door(for Crewmax): Reassembly
    REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL FRONT DOOR WEATHERSTRIP LH (a) Attach the 38 clip ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0148