Toyota Tundra Service Manual: Installation

Toyota Tundra Service Manual / Vehicle Interior / Pre-collision / Pre-collision System Warning Buzzer / Installation

INSTALLATION

PROCEDURE

1. INSTALL SKID CONTROL BUZZER ASSEMBLY

(a) Connect the connector.

NOTICE:

Securely connect the connector.

(b) Attach the clamp to install the skid control buzzer assembly.

NOTICE:

Securely insert the clamp into the bracket of the instrument panel reinforcement.
If the buzzer is dropped, replace it.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Click here

3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

4. INSTALL INSTRUMENT SIDE PANEL LH

Click here

5. INSTALL COWL SIDE TRIM BOARD LH

Click here

6. INSTALL FRONT DOOR SCUFF PLATE LH

Click here

See More:

Toyota Tundra Service Manual > Air Pump: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AIR PUMP ASSEMBLY (a) Start the engine and warm it up. (b) Turn the ignition switch off. (c) Connect the 400 A probe of an ammeter to the (+) wire of the air pump assembly. (d) Connect the Techstream to the DLC3. (e) Turn the ignition switch to ON and turn ...

Toyota Tundra Service Manual: Installation

Inspection

Removal

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual