Toyota Tundra Service Manual: Front Radar Sensor Beam Axis Not Adjusted (C1A14)

Toyota Tundra Service Manual / Vehicle Interior / Pre-collision / Pre-collision System / Front Radar Sensor Beam Axis Not Adjusted (C1A14)

DESCRIPTION

After installing a new millimeter wave radar sensor assembly, if sensor beam axis adjustment has not been performed, DTC C1A14 will be stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1A14

Front Radar Sensor Beam Axis Not Adjusted

When the vehicle is being driven at a speed of 10 km/h (7 mph) or more, incompletion of millimeter wave radar sensor assembly beam axis alignment is detected for approximately 1 second or more.
  • Millimeter wave radar sensor assembly adjustment has not been performed or has not been completed normally
  • Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
  • If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.

    Click here

PROCEDURE

1.

ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Perform millimeter wave radar sensor assembly adjustment.

Click here

NEXT

2.

CHECK FOR DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

(b) Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

(c) Check for DTCs.

Click here

Result

Proceed to

DTC C1A14 is not output

A

DTC C1A14 is output

B
A

END (SENSOR BEAM AXIS ADJUSTMENT WAS NOT COMPLETED)
B

3.

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly.

Click here

(b) Adjust the millimeter wave radar sensor assembly.

Click here

NEXT

4.

CLEAR DTC (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

NEXT

END
    Front Radar Sensor Incorrect Axial Gap (C1A11)

    Yaw Rate Sensor (C1A46)

    See More:

    Toyota Tundra Service Manual > Name Plate: Removal
    REMOVAL PROCEDURE 1. REMOVE FRONT FENDER PLATE LH HINT: When removing the front fender plate LH, heat the vehicle body and front fender plate LH using a heat light. Standard: Item Temperature Vehicle Body 40 to 60°C (104 to 140°F) Front Fender Plate LH 20 to 30°C (68 to 86°F) NOTICE: Do not heat ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0332