INSPECTION PROCEDURE 1. INSPECT CENTER FRONT SEAT BELT ASSEMBLY RH 
CAUTION: Do not disassemble the retractor. (a) Before installing the seat belt, check the ELR. (1) When the inclination of the retractor is 15° or less from its installed position, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45° from its installed position, check that the belt locks. If the operation is not as specified, replace the seat belt assembly. (b) Check the fastening function of the child restraint system. NOTICE: The check should be performed with the outer belt installed. (1) When the belt is pulled out fully, the belt should automatically start to retract. (2) After the belt has fully retracted, the belt should be able to be pulled out and retracted again. If the operation is not as specified, replace the belt assembly. |
Toyota Tundra Service Manual > Touch Select 2-4 And High-low System: Transfer Synchronization Actuator Circuit High (P17A7)
DESCRIPTION This DTC is detected when a short to B+ is detected in the solenoid coil drive circuit. DTC Code DTC Detection Condition Diagnosis Condition Malfunction Status Malfunction Time Other Trouble Area P17A7 Ignition switch ON (when not switching between 2WD and 4H) Short to B+ in the solenoid ...
