INSTALLATION PROCEDURE 1. INSTALL CENTER FRONT SEAT BELT ASSEMBLY RH (a) Align the seat frame's claws with the seat belt retractor positioning holes. (b) Install the seat belt with the nut and bolt. HINT: First install the bolt, and then install the nut. Torque: for bolt : 7.5 N·m {76 kgf·cm, 66 in·lbf} for nut : 42 N·m {428 kgf·cm, 31 ft·lbf} 2. INSTALL FRONT SEAT HEADREST SUPPORT
3. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY
4. INSTALL SEAT FASTENER COVER
5. INSTALL CENTER FRONT SEAT ARMREST COVER
6. INSTALL FRONT SEAT TRAY
7. INSTALL RECLINING REMOTE CONTROL BEZEL
8. INSTALL LOWER FRONT SEAT SHOULDER BELT COVER
9. INSTALL UPPER REAR SEATBACK LOCK BEZEL
10. INSTALL FRONT SEAT SHOULDER BELT COVER
11. INSTALL FRONT SEAT HEADREST ASSEMBLY 12. INSTALL CENTER SEATBACK ASSEMBLY
13. CONNECT CENTER FRONT SEAT BELT ASSEMBLY RH (a) Install the belt anchor with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} 14. INSTALL CENTER SEAT CUSHION SHIELD RH
15. INSTALL CENTER SEAT CUSHION SHIELD LH
16. INSTALL CENTER FRONT SEAT ASSEMBLY (a) Install the front seat (see page ). 17. INSTALL FRONT SEAT ASSEMBLY (for Power Seat) (a) Install the front seat (see page ). 18. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) (a) Install the front seat (see page ). |
Toyota Tundra Service Manual > Front Seat Inner Belt Assembly: Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (for Manual Seat) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition A-3 (LSP+) - B-1 Always Below 1 Ω A-4 (LSP-) - B-2 Always Below 1 Ω If t ...