Components COMPONENTS ILLUSTRATION
Installation INSTALLATION PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY
(a) Install the belt with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} NOTICE: Do not overlap the anchor part of the seat belt and protruding parts of the vehicle body. 2. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
(a) Install the belt with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} NOTICE: Do not overlap the anchor part of the seat belt and protruding parts of the vehicle body. Removal REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) Remove the rear seat (see page 2. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
(a) Remove the bolt and belt. 3. REMOVE REAR SEAT INNER BELT ASSEMBLY
(a) Remove the bolt and belt. |
Toyota Tundra Service Manual > Touch Select 2-4 And High-low System: Lost Communication with ECM / PCM "A" (U0100,U0122)
DESCRIPTION This DTC is detected if communication is lost between the ECM and skid control ECU. DTC Code DTC Detection Condition Diagnosis Condition Malfunction Status Malfunction Time Other Trouble Area U0100 Ignition switch ON Communication is lost between ECM and 4 wheel drive control ECU 5 secon ...