INITIALIZATION 1. INITIALIZE FRONT POWER SEAT CONTROL SYSTEM NOTICE: The position sensor initialization must be performed if one of the following occurs.
(a) Perform the initialization operation (1) Turn the ignition switch to ON. (2) Press the front vertical switch of the position control ECU and switch assembly downward 3 times. (3) Within 10 seconds of the above operation, begin the following operation: perform the rearward reclining operation and upward lifter operation simultaneously for 10 seconds or more (buzzer sounds for 0.5 seconds). This will start the initialization. |
Toyota Tundra Service Manual > Differential Carrier Assembly(for 1ur-fe): Removal
REMOVAL PROCEDURE 1. REMOVE REAR WHEEL 2. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft for 2WD (See page ). (b) Remove the propeller shaft for 4WD (See page ). 3. DRAIN DIFFERENTIAL OIL 4. REMOVE REAR AXLE SHAFT LH (a) Remove the rear axle shaft LH (See page ). 5. REMOVE REAR AXLE ...
