Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT SEATBACK HEATER ASSEMBLY LH

(a) Check the resistance of the front seatback heater assembly LH.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	Seatback heater temperature 23°C (73°F)	4.16 to 5.08 Ω

If the result is not as specified, replace the front seatback heater assembly LH.

Text in Illustration

*a	Component without wire harness connected (Front Seatback Heater Assembly LH)

2. INSPECT FRONT SEATBACK HEATER ASSEMBLY RH

(a) Check the resistance of the front seatback heater assembly RH.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	Seatback heater temperature 23°C (73°F)	4.16 to 5.08 Ω

If the result is not as specified, replace the front seatback heater assembly RH.

Text in Illustration

*a	Component without wire harness connected (Front Seatback Heater Assembly RH)

Toyota Tundra Service Manual > Steering Column Assembly(for Manual Tilt And Manual Telescopic Steering Column): Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: When using a vise, do not overtighten it. PROCEDURE 1. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) (a) Using a screwdriver, widen the claws attached to the upper bracket by approximately 1.0 mm (0.0394 in.). (b) Pull out the transponder ...

Toyota Tundra Owners Manual