Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY LH

(See page )

2. REMOVE FRONT SEAT CUSHION SHIELD LH

3. REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD LH

4. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

5. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

6. REMOVE SEPARATE TYPE FRONT SEATBACK PAD

7. REMOVE FRONT SEATBACK WIRE LH (for Driver Side)

8. REMOVE FRONT SEATBACK WIRE RH (for Front Passenger Side)

9. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH

(a) Detach the 2 clips and 2 guides to remove the lumbar support adjuster assembly LH.

10. REMOVE FRONT SEATBACK HOOK

(a) Remove the 2 front seatback hooks from the lumbar support adjuster assembly LH.

11. REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)

    Installation

    Power Seat Switch(w/o Seat Position Memory System)

    See More:

    Toyota Tundra Service Manual > Ultrasonic Sensor(for Front Side): Installation
    INSTALLATION PROCEDURE 1. INSTALL NO. 1 ULTRASONIC SENSOR (for Steel Type Bumper) (a) Install the No. 1 ultrasonic sensor as shown in the illustration. NOTICE: Do not damage the bumper with the protrusion when installing the No. 1 ultrasonic sensor. 2. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (for S ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0242