Toyota Tundra Service Manual: Seat Memory Switch(w/ Seat Position Memory System)

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT SEAT MEMORY SWITCH

(a) Check the resistance of the seat memory switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 2 (M1) - 4 (E) Switch 1 pressed Below 1 Ω 3 (M2) - 4 (E) Switch 2 pressed 1 (MRY) - 4 (E) SET switch pressed If the result is not as specified, replace the seat memory switch. Text in Illustration *a Component without wire harness connected (Seat Memory Switch)

Installation

INSTALLATION

PROCEDURE

1. INSTALL SEAT MEMORY SWITCH

(a) Install the seat memory switch with the 2 screws.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

3. INSTALL FRONT DOOR ARMREST COVER LH

4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

5. INSTALL FRONT ARMREST UPPER BASE PANEL LH

6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

2. REMOVE FRONT ARMREST UPPER BASE PANEL LH

3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

4. REMOVE FRONT DOOR ARMREST COVER LH

5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

6. REMOVE SEAT MEMORY SWITCH

(a) Remove the 2 screws and seat memory switch.