Toyota Tundra Service Manual: Check Mode Procedure

Toyota Tundra Service Manual / Vehicle Interior / Supplemental Restraint Systems / Airbag System / Check Mode Procedure

CHECK MODE PROCEDURE

CHECK MODE (SIGNAL CHECK): DTC CHECK

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(d) Turn the Techstream on.

(e) Select "Signal Check" and proceed with checking using the Techstream.

NOTICE:

Select Signal Check on the Techstream to clear the DTCs (both current and history).

HINT:

DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
Perform check mode inspection when a malfunction in a squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.

Short in P/T Squib (LH) Circuit (B1905-B1908)

Data List / Active Test

See More:

Toyota Tundra Owners Manual > Steps to take in an emergency: If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt or snow: 1. Stop the engine. Set the parking brake and shift the shift lever to P. 2. Remove the mud, snow or sand from around the rear wheels. 3. Place wood, stones or some other material to help provide ...